Bahasa Indonesia English Language

EMS (Embedded Module Series) 30 A H-Bridge is a H-Bridge based on VNH3SP30 which can drive motor in forward and reverse with continuous current up to 30 A at 5,5 Volt - 36 Volt (5,5 Volt - 36 Volt for VNH2SP30). This module comes with current sensor circuit as feedback to controller. Dilengkapi dengan rangkaian sensor arus beban yang dapat digunakan sebagai umpan balik ke pengendali. This module can drive any inductive load, sudh as DC motor, stepper motor, relay, solenoid, etc.

Dimension : 7,4 cm (L) x 6,1 cm (W) x 1,9 cm (H)

  • Product Detail
  • Download
  • Application Note

Specifications :

  • Consist of 1 H-Bridge full driver. (IC VNH2SP30 has current sense feature).
  • Driver can drive continuous current up to 30 A when paralleled and support load voltage 5.5 V - 36 V.(max 16 V for VNH2SP30).
  • TTL/CMOS compatible.
  • Tri-state output.
  • MOSFET output with low resistance drain-source (typ. 0,034 ohm).
  • Support PWM up to 20 Khz.
  • Fault detection.
  • Short circuit and over temperature protection.
  • Under and overvoltage shutdown.
  • Reverse battery protection.
  • Seperate power line betwen circuit voltage and load voltage.
  • Industry standard PCB Design with two layer FR4 and plated through hole technology.
  • Fully compatible with SPC Gamepad Interface and support wide various microcontroller.

 

Includes :

  • 1x EMS 30 A H-Bridge.

Application Note Table

Article File Desc date
No data available in table