Bahasa Indonesia English Language

DT-ARM NUC120 Board is a NUC120RD2DN microcontroller (ARM Cortex-M0 from Nuvoton) development module. This module works with up to 48 MHz clock speed and has been equiped with internal bootloader, so you can burn your program directly from USB interface (without external programmer device).

  • Product Detail
  • Download
  • Application Note

Starting from SN 51.102.411, DT-ARM NUC120 Board is upgraded from NUC120RD2BN to NUC120RD2DN.

Specifications :

  • Based on NUC120RD2DN 64 KB APROM, 8 KB SRAM, 4 KB Data Flash, CPU ARM Cortex-M0).
  • Integrated with 12 MHz external crystal as main clock.
  • Integrated with 32.768 kHz as RTC clock.
  • 1x USB port.
  • 1x RS-485 port.
  • 3x UART channels with TTL level voltage (3.3 VDC / 5 VDC).
  • USB port can be used for serial interface as well as programing interface.
  • Comes with Serial Wire Debug for debugging and programming.
  • 45 I/O pins.
  • Integrated with internal temperature sensor.
  • 8x 12-bit ADC channels.
  • 3.3 VDC / 5 VDC (800 mA) working voltage.
  • Input supply voltage: 6,5VDC - 12VDC / 3,3VDC - 5VDC.

 

Includes :

  • 1x DT-ARM NUC120 Board.
  • 1x USB cable.

Application Note Table

Article File Desc date
AN221.pdf AN221.zip
[AN221] Web Server I/O Remote Menggunakan DT-ARM NUC120 Board dan EMS Ethernet Module

The goal of this application is to build a system to configure and read the input/output lines on DT-ARM NUC120 Board remotely using web server. In this application, we try to use the advantage of I/O and interrupt systems of NUC120RD2BN microcontroller on DT-ARM NUC120 Board.

11-06-2014
AN220.pdf AN220.zip
[AN220] Simple Web Server

In this application, we try to build a simple web server or website using EMS Ethernet Module dan DT-ARM NUC120 Board. EMS Ethernet Module acts as an ethernet controller module to bridge the communication between DT-ARM NUC120 Board (via SPI interface) with a computer network. Simple web content is stored in NUC120RD2BN's flash memory on DT-ARM NUC120 Board. The program in DT-ARM NUC120 Board is written in C language using Programmer editor and CooCox CoIDE compiler.

11-06-2014