Bahasa Indonesia English Language

DT-PROTO 40 Pin AVR Digital is a proto board based on ATmega8515 which comes with UART RS-232 communication port and designed to support In-system Programming feature. This module is suitable for experimenting, creating basic applications, or even for product prototype such as: LED display, motor driver controller, robot, data communication with computer, reading digital value from sensor, accessing memory and PPI.
Dimension: 12.1 cm (L) x 10.1 cm (W) x 2.2 cm (H)

  • Product Detail
  • Download
  • Application Note


  • Based on ATmega8515 microcontroller which has 8K byte Flash memory, 512 byte EEPROM, and 512 byte SRAM.
  • Compatible with other 40 pins digital AVR such as: AT90S8515, AT90S4414, ATmega161, and ATmega162.
  • Up to 32 I/O lines.
  • There are lines each of which is connected to RST, ICP, ALR, OC1B, X1, and X2 on microcontroller.
  • 9 - 12 VDC supply input, and there is 5 VDC output voltage for external circuit.
  • Integrated with LED indicator and 5x2 In-system Programming header (Atmel's standard) for programming using external programmer device.
  • 1x UART RS-232 communication port (RJ11).
  • Integrated with 4 MHz crystal.
  • External reset circuit with brown-out detector and manual reset switch.
  • Jumper for reset source selection.
  • 1.018 non through-hole pads for prototype area (suitable for DIP, pitch = 0,1").
  • Starting from s/n 51.46.060, DT-Proto 40 Pin AVR Digital will use PCB plated through hole with around 1008 pads.
  • 3 connected pads lines that can be used as voltage supply lines (VIN, GND, +5V) or other lines.
  • Comes with test code to test port A - port E and UART RS232 serial communication functionality.



  • 1x DT-PROTO 40 Pin AVR Analog.
  • 1x Serial Cable.
  • 1x quick start.
  • 1x CD-ROM.

Application Note Table

Article File Desc date
No data available in table