Bahasa Indonesia English Language
*) DISCONTINUE

DT-PROTO 28 PIN AVR is a proto board based on ATmega8 which has UART RS-232 Port and support In-System Programmer feature. Available pad array for additional electronics circuit. This module suitable for experiment, create prototype products, or create simple single chip application, such as LED display controller, driver motor controller, robot controller, data communication to PC, read value of digital or analog sensor, memory access and PPI.

Dimension : 10.1 cm (L) x 9.3 cm (W) x 2.2 cm (H)

  • Product Detail
  • Download
  • Application Note

Specifications :

  • Based on ATmega8 microcontroller with 8KByte Flash Memory, 512 EEPROM, 1KByte SRAM and Eight 10-bit ADC.
  • Support various of 28pin AVR analog, such as: AT90S2333, AT90S4433, ATmega28L, ATmega48, ATmega88, dan ATmega168.
  • 23 I/OAvailable option connection for RESET, AREF, X1 and X2 pin.9-12VDC power supply, and available 5V voltage output.
  • Comes with LED indicator and 5x2 header for downloading code using external device programmer ATMEL standard.
  • One UART RS-232 port through RJ11 connector.4Mhz crystal oscillator.External reset circuit with brown-out detector and manual reset button.
  • Available selected jumper for reset sources.Prototype area consist of 0.1inch 1,018 pad through-hole.
  • Begin SN 1.47.087, DT-Proto 28 Pin AVR Analog used PCB plated through-hole with 1008 pad array.
  • Available 3 line pads which connected each other, so can be used as power supply line (VIN, GND, 5VDC) or another line.
  • Comes with testing code to testing PORTA-PORTD and UART RS-232 communication.

 

Includes :

  • 1x DT-PROTO 28 Pin AVR Analog board.
  • 1x Serial cable.

Application Note Table

Article File Desc date
AN205.pdf AN205.zip
[AN205] Line Follower Robot berbasis kamera HaViMo 2.0 dengan sistem kendali PD

This application note will explain how to build a line follower robot with HaViMo 2.0 as sensor. This application note uses DT-PROTO 28 Pin AVR (with 8MHz external oscillator), EMS 1 A Dual H-Bridge, and USB2Dynamixel.

28-04-2014
AN188.pdf AN188.zip
[AN188] Implementasi Arduino pada DT Series

This application note will explain how to implement Arduino's bootloader and code into DT Series. This application uses DT-Proto 28-Pin AVR / DT-AVR ATmega328 CPU Module / DT-AVR ATmega1280 CPU Module and DT-HiQ AVR In-System Programmer / DT-HiQ AVR USB ISP.

23-12-2014