Bahasa Indonesia English Language

DT-PROTO 8 Pin AVR ATtiny13 based proto board is supporting In-system Programming. Available pad array to set up/applications. This module is suitable for experimenting, made a prototype of a product, or make a simple single-chip applications. For example, the application controller LED display controller drivers, motor, robots, motion control sensor reader both digital and analog sensors.

Dimensions: 9.1 cm (L) x 6 cm (W) x 2.2 cm (H)

  • Product Detail
  • Download
  • Application Note


  • Microcontroller ATtiny13 with 1 k bytes of Flash memory, 64 bytes of EEPROM, 64 bytes SRAM and 4-channel ADC with 10-bit resolution.
  • Support the AVR 8 pin variant, namely: ATtiny11, ATtiny15L, ATtiny12, AT90 (L) S2343 AT90 (L), S2323 and ATtiny22L.
  • Have up to 6 line input/output.
  • Power supply Input (VIN) 9-12 VDC output voltage available, + 5 V for a range of applications.
  • The LED indicators are available and 5 x 2 header for programming using the device in-system programmer Atmel standard.
  • External reset circuit with a brown-out detector and a manual reset button.
  • There is a jumper to select the source of the reset.
  • Prototype area consists of 434 non through-hole pad that is suitable for DIP components (pitch = 0.1 ").
  • There are 3 lines connected pad that can be used for the power supply line (VIN, GND, + 5V) or other lines.
  • Equipped with a testing program to test port B.



  • 1x PROTO DT-8 Pin AVR.
  • 1x quick start.
  • 1x CD.

Application Note Table

Article File Desc date
No data available in table