SPC Neo Stepper Motor 1.2A

Specifications:

• Based on ATtiny2313 driver control center as the motor.
• Based on the TB6612FNG as a motor driver IC, so it does not require additional driver module the motor.
• Able to control 1 piece motor unipolar stepper or bipolar.
• Being able to control a DC motor voltage has a value of 2, 5VDC-13, 5VDC and continuous current consumption maximum 1, 2A.
• Able to control rotation of motor in a half step or a full step.
• Require additional controllers in order to drive the motor.
• Full compatible with microcontroller module DT-51 Series, DT-AVR Series or DT-Basic Series.
• Has two types of interfaces for communication with the controller/microcontroller, UART, I2C and TTL.
• The movement of stepper motors: Continous Run, the Run Count Pulse, Brake and Stop.
• SPC Neo Stepper Motor 1.2 A work at level 4, power supply 8VDC-5, 4VDC.
• Pin input/output compatible with TTL and CMOS voltage levels.
• Using only 2 lines of data to UART TTL interface (Tx and Rx) and I2C (SDA and SCL).
• You cancascade up to 8 modules if you use I2C interface.
• I2C address settings through software (I2C address settings can only be done via the UART interface-TTL).
• Have the configuration pin-out 16-pin DIP 600mil, so the module can be directly connected to the project board, PCB or IC socket holes, 16-pin DIP 600mil.

Includes:

• 1x SPC Neo Stepper Motor 1.2 A.
• 1x DVD.